Logging Sendmail Level; Logging Sendmail Destination-Email - Edge-Core ECS4810-12M Layer 2 Management Manual

E
XAMPLE
This command sets the severity threshold used to trigger alert messages.
logging sendmail
Use the no form to restore the default setting.
level
S
YNTAX
D
EFAULT
Level 7
C
OMMAND
Global Configuration
C
OMMAND
The specified level indicates an event threshold. All events at this level or
higher will be sent to the configured email recipients. (For example, using
Level 7 will report all events from level 7 to level 0.)
E
XAMPLE
This example will send email alerts for system errors from level 3 through
0.
This command specifies the email recipients of alert messages. Use the no
logging sendmail
form to remove a recipient.
destination-email
S
YNTAX
D
EFAULT
None
Console(config)#logging sendmail host 192.168.1.19
Console(config)#
logging sendmail level level
no logging sendmail level
level - One of the system message levels
sent include the selected level down to level 0. (Range: 0-7;
Default: 7)
S
ETTING
M
ODE
U
SAGE
Console(config)#logging sendmail level 3
Console(config)#
[no] logging sendmail destination-email email-address
email-address - The source email address used in alert messages.
(Range: 1-41 characters)
S
ETTING
– 641 –
| System Management Commands
C 21
HAPTER
(page
SMTP Alerts
634). Messages