Ford Transit 2002 Owner's Manual page 1297

Transmission/Transaxle and Clutch - General
Information.
22. Connect the vehicle speed sensor (VSS)
electrical connector.
23. CAUTIONS:
Support the halfshaft. The inner joint
must not be bent more than 18 degrees. The
outer joint must not be bent more than 45
degrees.
Do not damage the halfshaft seal.
Make sure the snap ring is correctly
seated.
NOTE: Install a new snap ring.
Attach the left-hand halfshaft to the transaxle.
24. CAUTIONS:
Support the halfshaft. The inner joint
must not be bent more than 18 degrees. The
outer joint must not be bent more than 45
degrees.
Do not damage the halfshaft seal.
NOTE: Install a new center bearing cap and
locknuts.
Attach the right-hand halfshaft and the
intermediate shaft to the transaxle.
Install the center bearing cap and
locknuts.
25. Install the crossmember. For additional
information, refer to Section
Subframe and Mounting
26. Install the accessory drive belt cover.
27. Lower the vehicle.
28. Tighten the strut and spring assembly top mount
nuts on both sides.
http://vnx.su
502-00 Uni-Body,
System.