Ford Transit 2002 Owner's Manual page 1178

WARNINGS:
Do not smoke or carry lighted tobacco or open flame of any type when working on or
near any fuel related components. Highly flammable mixtures are always present and
may ignite. Failure to follow these instructions may result in personal injury.
This procedure involves fuel handling, Be prepared for fuel spillage at all times and
always observe fuel handling precautions. Failure to follow these instructions may result
in personal injury.
CAUTIONS:
Diesel fuel injection equipment is manufactured to very precise tolerances and fine
clearances. It is therefore essential that absolute cleanliness is observed when working
with these components. Always install blanking plugs to any open orifices or lines.
CAUTION: The generator must be
4.
protected from contamination. Failure to
follow this instruction may cause premature
failure of the generator.
Protect the generator with lint-free material to
prevent contamination.
5. CAUTION: Protect the fuel metering
valve and fuel temperature sensor electrical
connectors to prevent contamination with the
cleaning fluid.
Clean the fuel pump and surrounding areas.
For additional information, refer to:
Injection Component Cleaning - Vehicles With:
Common Rail Fuel Injection
Charging and Controls - 1.8L Duratorq-TDCi
(Lynx) Diesel/1.8L Duratorq-TDDi (Lynx) Diesel,
General Procedures).
6. Disconnect the fuel temperature sensor electrical
connector (high-pressure fuel supply line shown
removed for clarity).
7. Using the Pneumatic vacuum
foreign material from the area around the fuel
temperature sensor.
8. Remove the fuel temperature sensor (fuel pump
shown removed for clarity).
Install a blanking plug to the open port on
the fuel pump.
Installation
http://vnx.su
Fuel
(303-04B Fuel
gun, vacuum