Clutch - Clutch Disc and Pressure Plate
Removal and Installation
Special Tool(s)
Aligner, Clutch Disc
308-204 (16-067)
Locking Tool, Crankshaft
303-393 (21-168)
Transit/Tourneo Connect 2002.5 (06/2002-)
Removal
1. Remove the transmission. For additional
information, refer to Section
Transmission/Transaxle.
CAUTION: If the clutch pressure plate is
2.
to be re-used, undo the bolts evenly in
stages working diagonally until the
diaphragm spring is no longer under
pressure (about two turns).
Detach the clutch from the flywheel.
Remove the bolts and lift the clutch
pressure plate and disc from the guide
pegs.
Discard the bolts.
Installation
1. Centre the clutch disc on the pressure plate.
CAUTION: Tighten the bolts evenly,
2.
working diagonally, until the pressure plate is
fully in contact with the flywheel.
NOTE: Install new clutch pressure plate
bolts.
Install the clutch disc with the clutch pressure
plate.
1. Position the clutch pressure plate together
with the special tool and centred clutch
disc onto the guide pegs on the flywheel.
2. Tighten the clutch pressure plate bolts,
working diagonally.
http://vnx.su
Print
308-03 Manual