Ford Transit 2002 Owner's Manual page 1496

Climate Control System - General
Information - Air Conditioning (A/C)
Clutch Air Gap Adjustment
General Procedures
Materials
Name
Spacer washer set
Specification
1. Measurement for recessed pulley
Check the air gap A between the drive plate and
the pulley at 60 degree intervals around the
circumferance of the pulley, while operating the
A/C clutch several times by means of a 5A fused
jumper wire connected between the battery
positive terminal, A/C clutch and battery ground.
For additional information, refer to Specifications
in this section.
1. Belt pulley
2. Drive plate
2. Measurement for non recessed pulley
Check the air gap A between the drive plate and
the pulley at 60 degrees intervals around the
circumference. For additional information, refer
to Specifications in this section.
1. Belt pulley
2. Spacer washer
3. Drive plate
3. Remove the drive plate.
4. Correct air gap A as necessary using spacer
washers.
5. Install the drive plate. For additional information,
refer to Specifications in this section.
6. Check air gap A as described in step 1 or step 2.
Repeat steps 3-5 if necessary.
http://vnx.su
Transit/Tourneo Connect 2002.5 (06/2002-)
Air gap A (the difference measured
between the A/C clutch engaged and
disengaged)
Air gap A
Print