NOTE: Install a new engine rear mount
13.
center retaining nut.
NOTE: Do not fully tighten the engine rear
mount retaining nuts at this stage.
Install the engine rear mount.
14. Remove the special tools on both sides.
1. Loose the fender retaining bolts.
2. Remove the special tools.
3. Tighten the fender retaining bolts.
4. Install the fender retaining bolts.
15. Connect the transaxle breather tube to the
transaxle.
Clip the breather tube.
16. Raise and support the vehicle.
For additional information, refer to:
02 Jacking and Lifting, Description and
Operation).
17. Install the accessory drive belt cover.
18. Connect the vehicle speed sensor (VSS)
http://vnx.su
Lifting
(100-