Ford Transit 2002 Owner's Manual page 1165

Electronic Engine Controls - Powertrain
Control Module (PCM)—Vehicles Built
From: 08/2006
Removal and Installation
General Equipment
Worldwide Diagnostic System (WDS)
Removal
NOTE: Removal steps in this procedure may contain installation details.
Transit/Tourneo Connect 2002.5 (06/2002-)
NOTE: This step is only necessary when
1.
installing a new component.
Upload the PCM configuration information using
the Programmable Modules Installation routine.
General Equipment:
System (WDS)
2. Disconnect the battery ground cable.
Refer to: Battery Disconnect and Connect
01 Battery, Mounting and Cables, General
Procedures).
3. Remove the right-hand side wheel and tire.
Refer to: Wheel and Tire
Tires, Removal and Installation).
5. Remove the PCM security shield (if equipped).
http://vnx.su
Worldwide Diagnostic
(414-
(204-04 Wheels and
4.
6. Torque:
10 Nm
Print