The output shaft forms a unit with the output pinion. All of the remaining parts are pressed
or mounted on the output shaft.
The 1st, 2nd, 5th and reverse gear are all located on the output shaft.
1st and 2nd gear are both double-synchronised.
The output shaft runs on separate taper roller bearings on the clutch housing side and the
transmission housing side halves of the housing.
Item
Part Number
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
-
Description
Taper roller bearing (clutch housing side)
Output pinion (inseparable)
Output shaft
1st gear needle roller bearing
1st gear wheel
Inner synchroniser ring - 1st gear
Synchroniser cone - 1st gear
Outer synchroniser ring - 1st gear
Complete synchroniser assembly for 1st/2nd gear
Snap ring
Outer synchroniser ring - 2nd gear
2nd gear synchroniser cone
http://vnx.su