Do not damage the halfshaft oil seal.
NOTE: Plug the transaxle to prevent oil loss
or dirt ingress.
Detach the left-hand halfshaft from the
transaxle and secure it to one side.
Discard the snap ring.
Allow the oil to drain into a suitable
container.
20. Remove the intermediate shaft center bearing
cap.
Discard the center bearing cap and
locknuts.
CAUTIONS:
21.
Support the halfshaft. The inner joint
must not be bent more than 18 degrees. The
outer joint must not be bent more than 45
degrees.
Do not damage the halfshaft oil seal.
NOTE: Plug the transaxle to prevent oil loss
or dirt ingress.
Detach the right-hand halfshaft and the
intermediate shaft from the transaxle and secure
it to one side.
Allow the oil to drain into a suitable
container.
22. Disconnect the VSS electrical connector.
23. Remove the accessory drive belt cover.
http://vnx.su