Fit the bearing races using the press:
1. Input shaft using 204-017 (14-010).
2. Output shaft using 205-075 (15-036).
3. Differential using 204-050 (14-024).
NOTE: Do not oil taper roller bearings which
6.
are to be used again. Install new taper roller
bearings untreated.
Fit the input shaft and the output shaft in the
transmission housing.
Engage fourth gear.
Fit the input shaft and the output shaft
together in the transmission housing.
NOTE: Do not oil taper roller bearings which
7.
are to be used again. Install new taper roller
bearings untreated.
Install the differential (illustration shows 1.8L
diesel engine).
NOTE: Check that the mating surface is
8.
clean.
Position the clutch-end housing section.
Attach the special tool to the transmission
housing flange using the longer bolt.
9. Install the clutch-end housing sections.
Tighten the 16 flange bolts uniformly.
10. Install the special tool.
http://vnx.su