Ford Transit 2002 Owner's Manual page 1394

Fuel Tank and Lines - Fuel Tank—1.8L
Duratec-DOHC (85kW/115PS) - Zetec
Removal and Installation
Special Tool(s)
Wrench, Fuel Tank Sender Unit
(310-069) 23-055
General Equipment
Transmission jack
Materials
Name
Grease
WARNINGS:
Do not smoke or carry lighted tobacco or open flame of any type when working on or
near any fuel related components. Highly flammable vapors are always present and may
ignite. Failure to follow these instructions may result in personal injury.
This procedure involves fuel handling. Be prepared for fuel spillage at all times and
always observe fuel handling precautions. Failure to follow these instructions may result
in personal injury.
The fuel system remains pressurized for a long time after the ignition is switched off.
The fuel pressure must be released before attempting any repairs. Failure to follow these
instructions may result in personal injury.
6. Remove the components in the order indicated in the following illustration(s) and table
(s).
Specification
SA-M1C9107-A
1. Release the fuel system pressure. For additional
information, refer to Section
System - General Information
System - General
2. Disconnect the battery ground cable. For
additional information, refer to Section
Battery, Mounting and
3. Drain the fuel tank. For additional information,
refer to Section
Information
Information.
4. Raise and support the vehicle. For additional
information, refer to Section
Lifting.
5.
flexible pipe may cause damage resulting in
failure.
Support the flex pipe with a support wrap or
suitable splint.
http://vnx.su
Transit/Tourneo Connect 2002.5 (06/2002-)
Information.
Cables.
310-00A Fuel System - General
/ 310-00B Fuel System - General
CAUTION: Over bending of the exhaust
Print
310-00A Fuel
/ 310-00B Fuel
414-01
100- 02 Jacking and