NOTE: Note the installing position of the
14.
engine support bar adapters.
Install the special tools on both sides.
1. Remove the fender retaining bolts.
2. Loose the fender retaining bolts.
3. Install the special tools.
4. Tighten the fender retaining bolts.
15. Install the special tools.
16. Raise and support the vehicle.
For additional information, refer to:
02 Jacking and Lifting, Description and
Operation).
17. Remove the crossmember.
For additional information, refer to:
Crossmember
(502-00 Uni-Body, Subframe and
Mounting System, Removal and Installation).
18. Detach the gearshift cables from the transaxle.
1. Detach the gearshift cables from the
gearshift and selector lever.
2. Turn the abutment sleeves clockwise and
detach the cables from the bracket.
CAUTIONS:
19.
Support the halfshaft. The inner joint
must not be bent more than 18 degrees.
The outer joint must not be bent more than
45 degrees.
http://vnx.su
Lifting
(100-