15. Detach the gearshift cables from the transaxle.
1. Detach the gearshift cables from the
gearshift and selector lever.
2. Turn the abutment sleeves clockwise and
detach the cables from the bracket.
16. Disconnect the vehicle speed sensor (VSS)
electrical connector.
17. Lower the vehicle.
18.
NOTE: Do not disconnect the starter motor
electrical connector.
Remove the starter motor upper retaining bolts.
19. Remove the transaxle upper retaining studs.
20. Install the special tools.
21. Remove the engine rear mount center retaining
nut.
Discard the nut.
http://vnx.su