Table of Contents
Advertisement
Starting System - Starting System—
Vehicles Built From: 08/2006
Diagnosis and Testing
Refer to Wiring Diagrams Section 303-06, for schematic and connector
information.
Inspection and Verification
1. 1. Verify the customer concern.
2. 2. Visually inspect for obvious signs of electrical damage.
Visual Inspection Chart
3. 3. If an obvious cause for an observed or reported concern is found, correct the cause
(if possible) before proceeding to the next step.
4. 4. If the cause is not visually evident, verify the symptom and refer to the Symptom
Chart.
Symptom Chart
Symptom
The engine does not
crank/the relay does
click
The engine does not
crank/the relay does
not click
The engine cranks
slowly
Electrical
Fuse(s)
Wiring harness
Electrical connector(s)
Relay
Central junction box (CJB)
Battery junction box (BJB)
Switch(es)
Battery
Starter motor
Possible Sources
*
Battery.
*
REFER to:
and Cables, Diagnosis and Testing).
*
Relay.
*
CARRY OUT the relay Component Test. REFER to
the wiring diagrams.
*
Circuit(s).
*
GO to Pinpoint Test
*
Starter motor.
*
CARRY OUT the starter motor Component Test
using the WDS.
*
Battery.
*
REFER to:
and Cables, Diagnosis and Testing).
*
Fuse(s).
*
INSTALL a new fuse as necessary. If the fuse
fails again check for short to ground.
*
Passive anti-
*
REFER to:
theft system
Theft - Passive, Diagnosis and Testing).
(PATS).
*
Ignition switch.
*
GO to Pinpoint Test
*
Circuit(s).
*
Battery.
*
REFER to:
and Cables, Diagnosis and Testing).
*
Starter motor.
*
CARRY OUT the starter motor Component Test
using the WDS.
*
Circuit(s).
*
GO to Pinpoint Test
http://vnx.su
Transit/Tourneo Connect 2002.5 (06/2002-)
Action
Battery
(414-01 Battery, Mounting
A.
Battery
(414-01 Battery, Mounting
Anti-Theft - Passive
(419-01B Anti-
B.
Battery
(414-01 Battery, Mounting
C.
Print
Hide quick links:
Advertisement
Table of Contents
