of the mating surface (even 2 mm bead of
sealant).
32. Measure the turning torque.
Engage fourth gear.
Measure the turning torque.
If the turning torque is too high, all the
measurements (to establish the required
shim thickness) must be repeated.
Vehicles with diesel engine
33. Fit the speedometer drive pinion.
Insert the drive pinion.
Carefully drive in the roll pin.
All except vehicles with a diesel engine
34. Install the vehicle speed sensor (VSS).
All vehicles
35. Install the front driveshaft oil seals.
http://vnx.su