Ford Transit 2002 Owner's Manual page 1226

prevent fluid loss or dirt ingress.
Detach the left-hand halfshaft from the
transmission using the special tools and secure
it to one side.
Allow the oil to drain into a suitable
container.
Discard the snap ring.
8. Using the special tool, remove the halfshaft oil
seal.
Installation
1. Using the special tool, install the halfshaft oil
seal.
Drive the seal home.
2. CAUTIONS:
Secure the halfshaft to prevent damage
to the constant velocity joints. The inner
constant velocity joint must not be bent more
than 18 degrees. The outer constant velocity
joint must not be bent more than 45
degrees.
Ensure that the halfshaft oil seal is not
damaged.
Ensure that the snap ring is correctly
located in the groove.
NOTE: Fit a new halfshaft snap-ring.
Attach the halfshaft to the transmission.
3. WARNING: Install a new lower
suspension arm ball joint retaining nut.
Failure to observe this instruction can lead to
injury.
CAUTION: Protect the heat shield using
http://vnx.su