Ford Transit 2002 Owner's Manual page 1232

11. Remove the crossmember. For additional
information, refer to Section
Subframe and Mounting
12. Remove the intermediate shaft center bearing
cap.
Discard the center bearing cap and
locknuts.
CAUTIONS:
13.
Support the halfshaft. The inner joint
must not be bent more than 18 degrees. The
outer joint must not be bent more than 45
degrees.
Do not damage the halfshaft seal.
Plug the transaxle to prevent oil loss or
dirt ingress.
Detach the right-hand halfshaft and the
intermediate shaft from the transaxle and secure
it to one side.
Allow the oil to drain into a suitable
container.
CAUTIONS:
14.
Support the halfshaft. The inner joint
must not be bent more than 18 degrees.
The outer joint must not be bent more than
45 degrees.
Do not damage the halfshaft seal.
Plug the transaxle to prevent oil loss or
dirt ingress.
Using the special tools, detach the left-hand
halfshaft from the transaxle and secure it to one
side.
Discard the snap ring.
Allow the oil to drain into a suitable
container.
http://vnx.su
502-00 Uni-Body,
System.