INVT Goodrive 300 Operation Manual page 62

inverters
Goodrive300
Functio
Name
n code
Hibernation
P01.20 restore delay
time
Restart after
P01.21
power off
The waiting
time of
P01.22
restart after
power off
Detailed instruction of parameters
come back to the running state automatically.
This function code determines the Hibernation delay
time. When the running frequency of the inverter is
lower than the lower limit one, the inverter will pause
to stand by.
When the set frequency is above the lower limit one
again and it lasts for the time set by P01.20, the
inverter will run automatically.
Note: The time is the total value when the set
frequency is above the lower limit one.
Setting range: 0.0~3600.0s (valid when P01.19=2)
This function can enable the inverter start or not after
the power off and then power on.
0: Ddisable
1: Enable, if the starting need is met, the inverter will
run automatically after waiting for the time defined by
P01.22.
The function determines the waiting time before the
automatic running of the inverter when powering off
and then powering on.
61
Function codes
Default Modif
value y
○
0.0s
○
0
○
1.0s