INVT Goodrive 300 Operation Manual page 53

inverters
Goodrive300
Functio
Name
n code
B frequency
P00.08 command
reference
Combination
P00.09 of the setting
source
Detailed instruction of parameters
to set P09. The running frequency of the inverter is
the value after PID effect. See P09 for the detailed
information of the given source, given value,
feedback source of PID.
8:MODBUS communication setting
The frequency is set by MODBUS communication.
See P14 for detailed information.
9:PROFIBUS communication setting
The frequency is set by PROFIBUS communication.
See P15 for the detailed information.
10:Ethernet communication setting(reserved)
11:CAN communication setting(reserved)
Note:A frequency and B frequency can not set as
the same frequency given method.
0:Maximum output frequency, 100% of
B frequency setting corresponds to the maximum
output frequency
1:A frequency command, 100% of B frequency
setting corresponds to the maximum output
frequency. Select this setting if it needs to adjust on
the base of A frequency command.
0: A, the current frequency setting is A freauency
command
1: B, the current frequency setting is B frequency
command
2: A+B, the current frequency setting is A frequency
command + B frequency command
3: A-B, the current frequency setting is A frequency
command - B frequency command
4: Max (A, B):The bigger one between A frequency
command and B frequency is the set frequency.
5: Min (A, B):The lower one between A frequency
command and B frequency is the set frequency.
Note:The combination manner can be shifted by
52
Function codes
Default Modif
value y
○
0
○
0