INVT Goodrive 300 Operation Manual page 50

inverters
Goodrive300
Functio
Name
n code
Communicati
on running
P00.02
commands
channel
Max. output
P00.03
frequency
Detailed instruction of parameters
reset.
0:Keypad running command
channel("LOCAL/REMOT" light off)
Carry out the command control by RUN, STOP/RST
on the keypad.
Set the multi-function key QUICK/JOG to
FWD/REVC shifting function (P07.02=3) to change
the running direction; press RUN and STOP/RST
simultaneously in running state to make the inverter
coast to stop.
1:Terminal running command channel
("LOCAL/REMOT" flickering)
Carry out the running command control by the
forward rotation, reverse rotation and forward
jogging and reverse jogging of the multi-function
terminals
2:Communication running command channel
("LOCAL/REMOT" on)；
The running command is controlled by the upper
monitor via communication
Select the controlling communication command
channel of the inverter.
0:MODBUS communication channel
1:PROFIBUS communication channel
2:Ethernet communication channel
3:CAN communication channel
Note: 1, 2 and 3 are extension functions which can
be used only when corresponding extension cards
are configured.
This parameter is used to set the maximum output
frequency of the inverter. Users should pay attention
to this parameter because it is the foundation of the
frequency setting and the speed of acceleration and
deceleration.
49
Function codes
Default Modif
value y
○
0
50.00H
◎
z