INVT Goodrive 300 Operation Manual page 56

inverters
Goodrive300
Functio
Name
n code
Motor
P00.15 parameter
autotuning
AVR function
P00.16
selection
P00.17 Reserved Reserved
Function
P00.18 restore
parameter
P01 Group Start-up and stop control
P01.00 Start mode
Detailed instruction of parameters
additional 1k carrier frequency.
Setting range:1.0~15.0kHz
0:No operation
1:Rotation autotuning
Comprehensive motor parameter autotune
It is recommended to use rotation autotuning when
high control accuracy is needed.
2: Static autotuning 1(autotune totally); It is suitable
in the cases when the motor can not de-couple form
the load. The antotuning for the motor parameter will
impact the control accuracy.
3: Static autotuning 2(autotune part parameters);
when the current motor is motor 1, autotune P02.06,
P02.07, P02.08; and when the current motor is
motor 2, autotune P12.06, P12.07, P02.08.
0:Invalid
1:Valid during the whole prodecure
The auto-adjusting function of the inverter can
cancel the impact on the output voltage of the
inverter because of the bus voltage fluctuation.
0:No operation
1:Restore the default value
2:Cancel the fault record
Note: The function code will restore to 0 after
finishing the operation of the selected function code.
Restoring to the default value will cancel the user
password, please use this function with caution.
0:Start-up directly:start from the starting frequency
P01.01
1:Start-up after DC braking: start the motor from the
starting frequency after DC braking (set the
parameter P01.03 and P01.04). It is suitable in the
55
Function codes
Default Modif
value y
◎
0
○
1
◎
0
◎
0
◎
0