Gear Plate Removal - Lexmark 5000 Service Manual

4093/4094

Gear Plate Removal

1. Remove all covers, refer to
page 4-5.
2. Unplug the power connector.
3. Remove the frame from the base and remove the carrier.
4. Remove the maintenance station assembly.
5. Remove the mid-frame assembly.
6. Unplug the paper feed motor.
7. Remove the two screws from the gear plate and remove the
gear plate. During reassembly, do not overtighten the screws,
as this may strip the plastic.
Gutter Pad Removal
1. Open the access door and remove the accent cover.
2. Remove the right exit tray base.
3. Remove the accent cover.
4. Remove the right cover.
5. Remove the maintenance station.
6. Remove the gutter pad.
Large Feed Roll Removal
1. Remove all covers, refer to
page 4-5.
2. Remove the carrier frame assembly from the base.
3. Remove the printhead carrier assembly.
4. Remove the maintenance station.
5. Remove the mid-frame assembly.
6. Remove the large feed roller.
"Covers (Complete) Removal," on
"Covers (Complete) Removal" on
Repair Information
4-9