Adding Bus Devices - Eaton i-on series Engineering Manual

i-on Range
To Leave Local Programming Mode and Save Changes
EITHER:
Press 
OR
Close the keypad tamper.
The keypad saves the changes you have made in its local memory.
You can now remove 12Vdc power, if required, or leave Installer Menu on the control unit.

Adding Bus Devices

To add bus devices to the system after you have connected them physically:
1. Enter the Installer Menu.
For keypads press and hold "A" and "" together. Release the keys when the
2.
keypad displays shows the new bus address.
For expanders press and hold the "Request Address" button. Release the button
3.
when the display shows the new bus address.
Basic Programming Procedures
Page 21