At The 762R (Or 768R/769R) - Eaton i-on series Engineering Manual

i-on Range
Press  until the display shows:
2.
Press .
3.
Press  .
4.
Press .
5.
30 50 160 The display shows the first in a list
of the available radio expanders, for example:
16 40 For i-on16 and i-on40 go to step 7.
30 160
Press  or  to see other radio expanders (if any).
6.
The display shows, for example:
Press .
7.
The display shows the first in a list of the radio
outputs on that expander, for example:
The bottom line of the display shows the outputs
current type.
Press  or  until the display shows the output
8.
you wish to add, for example:
Press .
9.
The display prompts you to make sure that the
receiver is in learn mode:
10. Press .
The control unit transmits its identity to the receiver.
When the receiver has successfully learned the
identity of the control unit it beeps twice.

At the 762r (or 768r/769r)

The 762 or 768r/769r gives a double "beep" and the display shows the device
number allocated to the transmitter. If you are using radio learn the display alternates
with the transmitter's signal strength, for example:
(If you are using Infrared learn the display shows a signal strength reading of zero.)
Note: If the display shows "--" and you hear a low tone from the sounder, then the 762r
has already learned that transmitter.
If you hear a double beep followed by a low tone then the 762 has insufficient
channels available for all the channels transmitted, but has allocated to the
transmitter those that are available.
Appendix IV


















D2 S7
Page 151