Menu Option; Factory Default - Eaton i-on series Engineering Manual

The Installer Menu

MENU Option

Wired outputs
Panel
Panel
Pulsed
Partitions
Delay
On time
Exp. W1-nn
Pulsed
Partitions
Delay
On time
Keypad 1-nn
Pulsed
Partitions
Delay
On time
Plug-by outputs
Pulsed
Partitions
Delay
Page 36

Factory Default

Name Type
Output 01 Siren
Output 02 Strobe
Output 03 Siren
Output 04 Strobe
Name Type
Siren Siren
Strobe Strobe
PAN>OP1 Siren
PAN>OP2 Strobe
PAN>OP3 Siren
PAN>OP4 Strobe
No
All outputs allocated to all partitions.
0 seconds
1 second
Name Type
W1>nn>01 Not Used
W1>nn>02 Not Used
W1>nn>03 Not Used
W1>nn>04 Not Used
No
All outputs allocated to all partitions.
0 seconds
1 second
Name Type
K1>nn>01 Not Used
No
All outputs allocated to all partitions.
0 seconds
1 second
Name Type
Output 01 Fire
Output 02 Hold Up Alarm
Output 03 Burglar Alarm
Output 04 Open / Close
Output 05 Zone Omit (System)
(see Note)
Output 06 Tamper
Output 07 Confirmed Alarm
Output 08 General Fault
Output 09 AC Fail
Output 10 Battery Fault
Output 11 Technical Alarm
Output 12 Alarm Abort
Output 13 Ext PSU Low Volt
Output 14 Ext PSU Fault
Output 15 24 Hour Alarm
Output 16 RF Fault
No
All outputs allocated to all partitions.
0 seconds
Notes
partitions.
Polarity
16 40
Normal
i-on16/i-on40 do not have separate
Normal
Siren and Strobe outputs.
Normal
Normal
Polarity
30 50 160
Normal
In addition to Siren and Strobe:
Normal
i-on30EX has one output
Normal
i-on50EX has three outputs
Normal
i-on160EX has four outputs.
Normal
NOTE: You cannot change Siren
Normal
and Strobe outputs to other types.
Appears only in a Partitioned
system.
Appears when Pulsed set to "Yes".
Appears when Pulsed set to "Yes".
Polarity
30 50 160
Normal
Appears only if EXP-W1 or EXP-
Normal
PSU added to bus.
Normal
"nn" = bus address
Normal
Appears only in a Partitioned
system.
Appears when Pulsed set to "Yes".
Appears when Pulsed set to "Yes".
Polarity Appears only when a suitable
keypad is fitted.
Normal
"nn" = keypad number
Appears only in a Partitioned
system.
Appears when Pulsed set to "Yes".
Appears when Pulsed set to "Yes".
30 40 50 160
Polarity i-on30 = Output 01...12
i-on40 = Output 01...12
Normal
i-on50 = Output 01...16
Normal
i-on160 = Output 01...16
Normal
Inverted
Note: on EUR systems the default
Normal
for plug-by output 5 is Zone Omit
(Setting)
Normal
Normal
Normal
Normal
Normal
Normal
Normal
Normal
Normal
Normal
Normal
Appears only in a Partitioned
system.
Appears when Pulsed set to "Yes".
i-on Range