Eaton i-on series Engineering Manual page 129

i-on Range
list of phone numbers. Press  and  to scroll to the required phone number followed by
 to select it. Key in the correct digits and then press .
The display then allows you to give the telephone number a name. The control unit will
display this name in the phone book to help you remember what destination you wanted
the message to go to.
Note that the control unit makes this number available in the User Menu. User 01 can edit
the number or enter a new telephone number in this slot at will. This allows the user to re-
direct any SMS message destined for this number. The user cannot disable the telephone
number by entering a blank number; the fact that they have changed the number is
logged.
Triggers
You can link a set of triggers to each message. To link a trigger select Communications –
SMS – Triggers.
The bottom line of the screen shows the first message. (Note that the display does not
show an entry for the Home Message. The control unit sends the text in the Home
Message at the beginning of every SMS message.) Press  or  to scroll to the message
you want to program and press  to select it. The bottom line of the display shows the first
in a list of triggers that you can chose to link to the message.
The display shows a "Yes" or "No" next to the trigger you have selected. Press  to
convert the "Yes" to an "No". You can select a "Yes" for more than one trigger in the list.
Press  when you have finished. The control unit will start sending an SMS message
whenever it detects one of the triggers that you have marked with a "Yes".
The triggers are categories, each of which covers a range of specific events in the control
unit:
Trigger Includes Events:
Alarms All types of alarm, including: 24 hour, Fire, HUA, Burg and test zone fail.
This also includes restores from those alarms.
Tampers All types of tampers, including: system, keypad, expander, sensor, user
code (excess digits), siren, WAM and radio keypad.
Sets/Unsets Any type of setting, part setting or unsetting of a partition (or part set) by
either keypad, remote control, or keyswitch.
System Any type of system event that is not an alarm, tamper or set/unset. This
includes: bus device missing, jamming, supervision fail, communications
failure or fault, AC lost, low or missing system battery, low battery on radio
device, Aux 12V fail.
PSTN SMS
Note: The i-on30EXD and i-on50EXD have a built-in communicator. If you fit a plug-on
communicator then this disables the built-in communicator. This option then
programs the plug on communicator (NOT the built-in communicator).
If you do not have a GSM module fitted, but are sending SMS messages by way of the
PSTN line, then you must program some extra information under this menu.
Select Reporting – SMS – PSTN SMS.
Installer Menu Options
Page 119