Eaton i-on series Engineering Manual page 25

i-on Range
Press  until the bottom line shows:
4.
Press  .
5.
The display shows (NOT i-on16 or i-on40):
Press  until the bottom line shows:
6.
Press .
7.
The display asks for confirmation.
16 If you are using an i-on16 (UK) then please
go to step 14.
Press  to load defaults.
8.
(Press  to go back to the Installer Menu without
changing defaults.)
For European (-EUR) versions of i-on software the
display asks you to select a country:
(The UK version does not give this option, go to step
11.)
Press  or  to show other countries, for example
9.
10. Press  to select the country you want.
16 i-on16 EUR loads defaults at this point. Go
to step 15.
30 40 50 160The display asks you to select
Partition Mode or Part Set Mode. (See page 7.)
11. EITHER: Press A to create a partition based system.
OR Press B to create a part setting system.
Note: You cannot change this setting without carrying out
another factory default.
30 40 : The i-on30EX, i-on40 control units are
Grade 2 only and do not show this display. Go to step
13.
50 160 The display asks you to select the
Security Grade. (See page 7.) Go to step 12.
50 160 Press  or  to select either Security
12.
Grade 3 or Security Grade 2 settings.
Note: If you change Grades then the keypad display
reminds you that all user codes will be defaulted.
(If you change your mind at this point and do not wish
Basic Programming Procedures
















Page 15