Downloader And The Log; Logging Tamper Events; Logging Software Updates; About - Eaton i-on series Engineering Manual

Installer Menu Options

Downloader and the Log

When Downloader connects to a control unit, the control unit logs the event as "Rem
Download". This indicates that Downloader successfully connected and disconnected.
The control unit logs a separate event "Unn Config Change" if Downloader changes the
configuration of the control unit. The user number recorded will be that for the Downloader
(see table above).

Logging Tamper Events

Tamper events are normally logged. However please note that the type of events that are
considered to be tampers depends to some extent on the options the Installer chooses in
System Options – Jamming and System Options – Supervision (see page 100). When
these options are set to "Tamper" then jamming or supervision failure events will be
recorded as tampers.

Logging Software Updates

The control unit logs the software version every time the system starts up from zero power.
To see the software version press  or  when the keypad displays the log message
"System Startup".

About

The About option in the Installer Menu offers information on the version and status of the
control unit.
If the control unit has a communications module fitted then the About option also provides
information about the module, including IP addresses and port numbers for modules
connected to the Internet.

Panel

This option shows:
The control unit model
The control unit's software revision
Whether the control unit is programmed as partition or part setting.
The installed languages and their versions.
Press  or  to see each item of information.

Expanders

30 50 160
This option shows the first item in list of all the expanders known to the control unit. If you
select an expander by scrolling up or down the list and then press , the display shows
the revision of software running on the expander.

Keypads

This option shows the first item in a list of the keypads known to the control unit. If you
select a keypad by scrolling up or down the list and then press tick, the display shows the
revision of software running on the keypad.
Note: This option does not work for keypads whose internal software is earlier than V.012.
If you find that the About option does not display an individual keypad's software version,
then you can check the keypad by briefly pressing the "A" and "" keys at the same time.
Page 136
i-on Range