User Programming; User Operation; To Set; To Unset - Eaton i-on series Engineering Manual

Appendix II
System Options

User Programming

User Code
01 1234
02 2222
03 3333

User Operation

To set:

Full System
Factory only
(Partition 2)
Office only
(Partition 3)

To Unset:

If User 02 (a member of the Factory department) sets their Factory partition and the Office
partition is already set, then the common foyer area will also start to set. When the user
closes the Front Door (zone 1) the whole system sets and the alarm response is raised to
Full alarm (Siren + Comms).
The same thing will happen if User 03 sets the Office partition when the Factory partition is
already set.
Page 142
Wired Zone Type
Confirmation Mode
Confirmation

Time
After Entry

Entry keypad

Lock
Sounder on

Siren on

Unconfirmed

reset
Confirmed Reset

Keypad Text
Siren Delay
Siren Time
Force Set
CSID
Silence Alerts
Type
Master User
Partition user
Partition user
User 01 enters code or Prox and selects a Partition.
(User 01 can select an individual Partition or full set the
whole system.)
Partition 2 User enter Code or Prox in Keypad 2
Partition 3 User enter Code or Prox in Keypad 1
First user to enter keys in their code or presents a Prox
tag
P3 = Yes
Select FSL if using all wired detectors
DD243 or BS8243
30 mins
2 zones
On
Unconfirmed
Unconfirmed
User
Installer
Enter Name of installer company
(default 0 mins)
(default 15 mins)
Off
Enter 4 digit ARC Scantronic reset code (if
required)
User
Partitions
Whole system – P2 + P3
P2 (Factory)
P3 ( Office)
i-on Range