Full Set Link - Eaton i-on series Engineering Manual

Installer Menu Options
Final Exit
Normal Alarm
Part Set Entry Route
This option controls how the system treats Entry Route zones during part set.
Entry Route
Final Exit
Strobe on Set/Part Set Strobe Set
When set to ON this option causes the control unit to activate any output
programmed as Strobe, plus the strobe on any 760ES wireless siren. The
outputs/strobes are active for ten seconds after the system sets. Strobe On Set
applies to Full Set and all the Part Sets.
Strobe on Unset/Part Set Strobe Unset
When set to ON this option causes the control unit to activate any output
programmed as Strobe, plus the strobe on any 760ES wireless siren. The
outputs/strobes are active for ten seconds after the system unsets. Strobe On Unset
applies to Full Set and all the Part Sets.

Full Set Link

30 40 50 160
The Full Set Link option is available on Partitioned systems. Full Set Link allows you to set
up a Common Area. See Appendix II for an example of how to use a Common Area.
Partition 1 is always the Common Area. You can link Partition 1 to any of the other
partitions. When all of the linked partitions are set, then the control unit Full Sets Partition
1. In addition, the system takes on whatever Alarm Response you have allocated to
Partition 1.
Page 82
In a Part Setting system, any Final Exit zones with
the Part Set B, C or D attributes will continue to act
as Final Exit zones during part set.
In a Partitioned system, any Final Exit zones,
belonging to the partition, with the Part Set attribute
will continue to act as Final Exit zones during part
set.
In a Part Setting System any Final Exit zones with
the Part Set B, C or D attributes will act as Normal
Alarm zones during part set.
In a Partitioned system, any Final Exit zones,
belonging to the partition, with the Part Set attribute
will act as Normal Alarm zones during part set.
In a Part Setting system, all Entry Route zones with
the Part Set B, C or D attributes will continue to act as
Entry Routes during part set.
In a Partitioned system, all Entry Route zones,
belonging to the partition, with the Part Set attribute
will continue to act as Entry Routes during part set.
In a Part Setting System, any Entry Route zones with
the Part Set B, C or D attributes will act as Final Exit
zones during part set.
In a Partitioned system, any Entry Route zones,
belonging to the partition, with the part set attribute
will act as Final Exit zones during part set.
i-on Range