Remotes; User Hold Up Alarms; Prox Tags - Eaton i-on series Engineering Manual

Installer Menu Options
not need to deactivate the output (This test applies to the UK only, and is compliant
with Form 175).
When you complete testing the outputs check that they are in the state you wish to leave
them in.
In addition, there is also a section for Comms Channels if the control unit is reporting to an
ARC using Fast Format.
If you select this option the bottom line of the keypad display will show you the first in a list
of the Fast Format comms channels available. Press  or  to see the other entries in
the list. For each channel that you wish to test press  to turn the channel "On". Once you
have selected all the channels to be tested, press . The control unit will then dial the
ARC and communicate the selected channels.
During the call you should see the following progress messages on the display:
"Dialling" then "Connected" followed by "Call Successful". If the call does not succeed then
the final message will be "Call Failed".

Remotes

The Test menu allows you to test user's remote control (you must have the remote control
to carry out the test). From the Installer Menu select Test-Remotes.
The keypad display shows a message asking you to press any button on the remote you
wish to test.
Press one of the remote's buttons.
The top line of the keypad display shows the remote's identity, the button you pressed and
the remote's owner. When testing a FOB-2W-4B the display identifies the buttons with a
letter: "S" = Set, "U" = Unset, "?" = Query, and "*" = Part Set (or programmable).
The bottom line of the display shows the action assigned to that button and the signal
strength. If the bottom line shows ">" then press  for more information.
Press all the other buttons on the remote to test them in the same way.

User Hold Up Alarms

The Test menu allows you to test user's HUA transmitters. You must have the HUA
transmitter to carry out the test. From the Installer Menu select Test – User Hold Up
Alarms.
The keypad display shows a message asking you to press the HUA buttons.
Press the HUA buttons, both at the same time. (The alarm system will not start a HUA
alarm as a result.)
The keypad display shows the HUA's owner. The bottom line of the display shows the
signal strength.
Note: To test wired HUA buttons use the Test – Walk Test option. To test HUA buttons on
a keypad, use the Test – Wired Keypad option. If you attempt to test either of these
functions while in User Hold Up Alarms you will NOT start a genuine HUA.)

Prox Tags

The Test menu allows you to test a user's proximity tag. (You must have the proximity tag
in order to test it.) From the Installer Menu select Test – Prox Tag.
The keypad display shows a message asking you to present the tag to the keypad.
Hold the prox tag up to the keypad.
Page 132
i-on Range