Keypads - Eaton i-on series Engineering Manual

i-on Range
See page 9 for the number of relay outputs available on each control unit.
USB Port
30 40 50 160.
The mini-USB port allows an Installer to program the control unit through a USB cable
from a PC to the control unit. The PC must be running Eaton Security Business's
Downloader.
The USB port also allows an Installer to apply software updates to the control unit or, in
European versions, install alternate language text files for the keypad display. To do this
the Installer must run Eaton Security Business's i-on Updater software on the connected
PC.
The Downloader and i-on Updater software is available to registered users from the
Touchpoint Product Support/Downloads pages on www.coopersecurity.co.uk.
Ethernet Port
40 50 160.
The Ethernet port also allows a local connection to a PC. The Ethernet connection is
designed to allow an Installer to program the control unit through a series of web pages
presented by a built-in web browser interface running on the control unit. Eaton's Security
Business recommends that you use Internet Explorer 8 or higher to browse the pages.
With software release 4.04 and higher Downloader can also use the Ethernet port to
program control units from a PC.
External Bell/Strobe Outputs
30 50 160.
The control unit has one external bell output to drive standard Self-Activating Bell (SAB) or
Self-Contained Bell (SCB) modules, and one output to activate a strobe. Expanders also
provide connectors for additional external sounders. See the Installation Guide for each
product for details of maximum current available for external bells.
Auxilliary Tamper
50 160.
The i-on50EX and i-on160EX control units also provide "Aux Tamper" terminals for
connecting the tamper wiring of any external device (other than keypads and expanders)
that needs tamper protection.
Extension Loudspeaker Connectors
If required the Installer can connect 16 Ohm extension loudspeakers to increase the
audibility of setting and unsetting tones. Each expander also provides connectors for one
16 Ohm extension loudspeaker. Note that you must not connect another loudspeaker in
parallel to the same connectors.

Keypads

In alarm systems built around i-on control units all the keypads connect directly to the
system bus.
The i-on control units with Release 4 software can use a range of keypads, including the i-
kp01, KEY-K01, KEY-KP01 and KEY-KPZ01.
Users can set and unset the system or partitions from the keypad, either by keying-in
access codes or presenting a prox tag (if the keypad has a prox tag reader).
Introduction
Page 3