New In Issue 7 (S/W Version 4.03 With New Keypads); New In Issue 8 (S/W Version 4.04) - Eaton i-on series Engineering Manual

Zone PA = SIA "PA", CID "120"
User RF PA = SIA "PA", CID "120"
Keypad PA (dual keys) = SIA "PA", CID "120"
Duress Code = SIA "HA", CID "121"
3. Automatic Remote Diagnostics is now available the for i-on30EX/D, i-on40, i-on50EX/D
and i-on160EX. (Please note that this must be activated within Downloader by a
Eaton's Security Business External Support Manager.)
Changes to Defaults:
1. Unset Comms now defaults to Enabled.
2. Fast Format channels 6 and 8 now default to Tamper and General Fault respectively.
3. Selected plug by outputs now default as follows:
4. Output 6 – Tamper, Output 8 – General Fault, Output 11 – Technical Alarm, Output 12
– Alarm Abort.
For –EUR panels Output 5 now defaults to Zone Omit (setting).
5. Default settle time is now 15 seconds.

New In Issue 7 (S/W version 4.03 with new keypads)

New Hardware
1. Control units now support KEY-KPZ01, KEY-KP01 and KEY-K01. The keypads have
new enclosures.
2. KEY-KPZ01 has an internal prox reader and connections for and external prox reader
(KEY-EP), two zones and one output.
3. KEY-KP01 has an internal prox reader and connections for an external prox reader
only.
4. KEY-K01 has no internal prox reader, no zones or outputs.
For Installers
Detectors/Devices Menu
1. The Wired Keypads menu allows you to enable/disable the zones and external prox
reader provided by the KEY-KPZ01, or external prox reader on the KEY-KP01. In
addition, you can also enable/disable the LEDs and set the display brightness for the
KEY-KPZ01, KEY-KP01 and KEY-K01.
Communications Menu
1. A HUA confirm code is now available in CID/SIA reporting.

New In Issue 8 (S/W version 4.04)

New Hardware:
1. The i-on expandable control units now support the EXP-WCC expander.
For Installers:
1. The ABCD LEDs are now linked to the ABCD keys. The ABCD LEDs glow whenever
all the partitions/part sets allocated to the keys are active.
Detectors/Devices Menu:
1. Zones connected directly to the control unit now appear on the keypad labelled as
"PAN<00<Znn" where nn is the zone number.
2. Log Only zones can now be allocated to Partitions, and can use the Chime attribute.
Page iv
i-on Range