Eaton i-on series Engineering Manual page 51

i-on Range
MENU Option
Restorals
Burg Comms Rearm
21CN FF Ack time
Send tamper as burg
Dynamic Test Call
Static Test Call
Unset Comms
Speech Dialler
Call Mode
Messages
Phone Book
Triggers
Destinations
Call Acknowledge
SMS
Call Mode
Messages
Phone Book
Triggers
PSTN SMS
Protocol
Service Centre Tel
Own Telephone No.
Line Fail Response
Line Fail Delay
Factory Default
Technical Alarm: No
Masking: Yes
Tampers: Yes
Set/Unset: Yes (see Note 2)
Part Set: Yes(see Note 2)
Reset: Yes (see Note 2)
Exit timeout: Yes
Omit: Yes
RF Supervision: Yes
RF Jamming: Yes (see Note 2)
RF Battery/PSU: Yes (see Note 2)
Panel Battery: Yes (see Note 2)
Mains Fail: Yes (see Note 2)
Faults: Yes (see Note 2)
Installer Mode: Yes (see Note 2)
User Code Changed: Yes
Time/Date Reset: No
Downloading: No
Enabled
Enabled
800ms
Disabled
Enabled
Disabled
Enabled
Disabled
None
Empty
None
None
Enabled
Disabled
Blank
Empty
None
ETSI Protocol 1 (i-on40 and i-onEX range)
TAP-8N1 (i-on16 only)
1470,17094009 (i-on40 and i-onEX range)
07785499993 (i-on16 only)
Empty
Audible
9s
The Installer Menu
Notes
2. This setting is required in order
to comply with EN50131.
Downloading and masking events
not available on i-on16.
Appears only when Report
Type=Fast Format AND when
Confirmation Mode = "Basic"
Appears only when Report
Type=Fast Format.
Appears when Report Type=CID
or SIA.
Appears only when StaticTest Call
disabled
Appears only when Dynamic Test
Call disabled.
To comply with EN50131, either
Static or Dynamic test calls must
be enabled. This is available only
when an i-sd02 is fitted and ARC
Communications enabled.
Only visible when suitable
communications module fitted.
Only visible on i-on30EXD and i-
on50EXD or when suitable
communications module fitted..
BT
Appears only protocol=UCP
Only visible on i-on30EXD, i-
on50EXD or when suitable
communications module fitted..
This setting is required in order to
comply with EN50131.
Page 41