Teach The Expander The Identity Of The Wam; At The Keypad - Eaton i-on series Engineering Manual

i-on Range
b). Press SELECT.
The blue LED 1 glows. The WAM is in menu 1.
3. Use menu 7 to go into mode selection as follows:
a) Press SELECT repeatedly until LED 7 glows.
b) Press SET.
The blue LEDs show the current mode. When delivered
from the factory the WAM is in mode 1 (LED 1 glowing).
4. If necessary, select mode 1 by pressing SELECT
repeatedly until LED 1 lights up.
(Note that LED 6 does not light up.)
5. Press SET.
The sounder gives a double "beep" and the LED 7
glows again. The WAM is now back in menu 7.
6. Leave programming mode as follows:
a) Press ESC/DEL.
The blue LED goes dark. The sounder gives a regular
beeping tone to remind you to replace the lid.
b) Replace the lid (or operate the tamper switch).
After a few seconds the red Trouble LED switches off
and the sounder gives a double beep confirmation tone.
NOTE: You must leave programming mode in order to save
the changes you have made.

Teach the Expander the Identity of the WAM

At The Keypad:

1. Enter Installer Menu.
Press .
2.
Press  until the display shows:
3.
Press .
4.
Appendix III
xn








Page 145