Disable Infrared Learning; Set To Manual Learn; Select Channel; Teach The Control Unit To The 762R Or 768R/769R - Eaton i-on series Engineering Manual

Appendix IV
9. Press Select until the display shows the next channel that you want to
set to output mode, for example:
10. Press Set.
The display shows the channel's current mode, for example:
11. Press Select until the display shows "n6", the Output Module Mode:
12. Press Set.
The display shows the Output Mode command "OP" again.
13. On a 768r/769r repeat steps 8 to 12 for all the other channels that you
want to use as outputs.

Disable infrared learning

Enter programming mode if the 762r or 768r/769r is not already there.
14. Press Select until the display shows the infrared Learn command "IR":
15. Press Set.
The display shows E if infrared learning is enabled, or d if infrared
learning is disabled (radio learning enabled).
16. Press Select until the display shows "disable".
17. Press Set.
NOTE: If you disable infrared learn then the receiver enables radio learn. If you enable
infrared learn then the receiver disables radio learn.

Set to manual learn

18. Press Select until the display shows the manual learn command "Ln".
19. Press Set.
The display shows the first available channel number, for example "C1":

Select channel

20. Press Select repeatedly until the display shows the channel number you
wish to use, for example:
The display flashes if there are no other devices on that channel. The
display is steady if there are already devices on the channel. The 762r
or 768r/769r will not show a channel number if it has already learned the
maximum number of devices to that channel.
21. Press Set.
The display shows "C" and the channel number ("C2" in the example),
followed by "d-" and then "S-" as the receiver scans for a new
transmitter.

Teach the Control Unit to the 762r or 768r/769r

At the Keypad:

1. Enter Installer Menu.
Page 150
i-on Range


C2
n1
n6
OP

Ln
Ir
E
d
Ir
Ln
C1
C2
C
C2
d-
S-