Eaton i-on series Engineering Manual page 69

i-on Range
Zones
(This option applies to the KEY-KPZ01.)
Use this option to enable or disable zones that connect directly to keypads. When enabled
the zones appear at the top end of the zone numbering range (see page 30) and have a
zone type of "Not Used". You must then use the Detectors/Devices – Detectors –
Program Zones option to give the keypad zone the properties you wish (see page 45). If
you disable the zones for a keypad after enabling them, then the control unit deletes all
properties belonging to those zones and sets their type to "Not Used".
Wired Zone Type
(This option applies to the KEY-KPZ01.)
You can program zones connected to keypads as any of the following wiring types:
2k2/4k7 FSL, 1k/1k FSL, 2k2/2k2 FSL, 4k7/4k7 FSL, 4-wire CC or 2-wire CC. (Note that
when using 4-wire CC wiring the keypad provides one zone, not two.)
Backlight
Use this option to control the brightness of keymat and display lighting on the KEY-KPZ01,
KEY-KP01 and KEY-K01 . There are two sub-options:
Mode This option control whether the backlight is on or off. When set to:
Timed The backlight is normally off, but glows when a user presses keys.
The backlight stays on for eight seconds after the last keypress or prox tag
use. The backlight also comes on during the entry time and when the
system is in alarm.
On
Off
Note: The Mode option has no effect if you have used the Local
This option controls the brightness of the backlight. The value "High"
Brightness
provides a brighter light than the value "Normal".
Note: The Brightness option has no effect on the KEY-KPZ01 if you have
External Prox
This option appears for the KEY-KPZ01 and KEY-KP01.
Use this option to enable or disable an external proximity tag reader wired into the
selected keypad. Note that this option appears only when a suitable keypad is connected
to the bus.
Deleting Wired Keypads
30 50 160
Use this menu option to delete keypads from the system. The option does two things: a)
clears the bus address stored within the keypad and b) deletes the record of that address
from the control unit. After using this option make sure you leave the Installer menu in
order to make the control unit save the change(s) you have made.
The backlight is permanently on.
The backlight is permanently off.
Programming Mode at the keypad to set the backlight behaviour.
fitted the BRIGHT jumper at the keypad.
Installer Menu Options
Page 59