Test; Sirens And Sounders - Eaton i-on series Engineering Manual

Hide thumbs Also See for i-on series:
Table of Contents

Advertisement

i-on Range
Disabled
Line Fail Delay
This menu controls the length of time that the control unit waits until starting an alert if the
plug-by communications line fails. The values available are 0 to 60 seconds.
Note: The control unit may take a few seconds to recognise a line fail. The actual delay
between line fail and the resulting alert will be slightly longer than the value you
program within this option.

Test

The control unit provides three options within the Installer Menu to help in testing: the Test
option itself, the View Log option to see what events have been recorded, and the About
option so that you can check on the release level of the software.
If you think that part of the system is not working correctly then you can use the Test
option to test various peripherals.
The Test option also lets you check the identity of Remote controls, Hold Up Alarms and
Proximity Tags.
You can test each part listed in the Test menu as follows:

Sirens and Sounders

This option allows you to test all the warning devices connected to the control unit. The
option is divided into sub-menus allowing you to test specific types of sounder, as shown
below:
Ext. Radio Sirens
Wired Sirens
Loudspeakers
Wired Keypads
Note that options for radio sirens will not appear if the control unit has not learned any
radio sirens. (The keypad displays the message "No Devices!".)
Select the type of sounder you wish to test and press . The sub-menu gives you the
option to test all sounders in a category at once, or to select individual partitions and test
cancels any programmed siren delay if the line is out of order
when an alarm occurs.
The control unit does not monitor the telephone line.
This option presents a list of the learned-in radio sirens. Select
a siren for testing by pressing  or . Note that both siren and
strobe should operate.
This option allows you to operate all outputs programmed as
"Siren" and "Strobe".
Either: Select "All Sirens" to operate all sirens at once.
OR: Press  or  to select the sirens for an individual
partition.
With this option you can test any loudspeakers connected to
the system. Either: Select "All Loudspeakers" to operate all
loudspeakers at once.
OR: Press  or  to select the loudspeakers for an individual
partition.
Use this option to test the sounders on the wired keypads.
Either: Select "All keypad sounders" to operate all wired
keypad sounders on the system at once.
OR: Press  or  to select the wired keypads sounders for an
individual partition.
Installer Menu Options
Page 127

Advertisement

Table of Contents
loading

Table of Contents