Eaton i-on series Engineering Manual page 122

Installer Menu Options
PA, PR Zone HUA (PA) and restore
Keypad HUA (PA), Keypad HUA (PA) restore
RF HUA (PA), RF HUA (PA) restore
Radio keypad HUA (PA), radio keypad HUA (PA)
restore
PT, PJ Zone HUD fault and restore
RS Downloading successful
RU Downloading failed
TA, TR Keypad tamper and restore
Detector tamper and restore
Lid tamper and restore
Bell tamper and restore
Radio keypad tamper and restore
External siren tamper and restore
WAM tamper and restore
TA, TR WAM trouble and restore
UA, UR Technical alarm and restore
XQ,HQ Jamming fail and restore*
XT, XR Zone low battery fail and restore
YA, YH Zone External Warning Device fault and restore
YM, YR Control unit battery low/ missing and restore
YM, YR External battery fault and restore
YP, YQ Smoke/WAM psu fail and restore
YP, YQ, Fail and restore for: Aux 12V, Aux 14.4V, Bell 12V,
Bus 12V, System 12V
YT, YR Ext Siren/WAM low battery fail and restore
YT, YR Control unit battery low/fail and restore
YT, YR External PSU low volts via zone n
YW System error
*Notes:
1. The control unit communicates Jamming, Supervision when the system is unset.
Restorals
When you enable a CID/SIA Report Group, or when you use Fast Format reporting, the
control unit sends the relevant telegram both when an event occurs, and when the
condition causing the event stops. The second transmission of the telegram is also called
a "restore".
You can enable or disable restoral reporting by selecting Communications – ARC
Reporting – Restorals. The options available are:
Disabled
Restore off. The control unit does not communicate restores.
Enabled.
Restore on. The control unit does communicate restores.
Page 112
i-on Range
Hold Up Alarm
Faults
Downloading
Tampers
Faults
Technical Alarm
RF Jamming
RF Battery/PSU
Fault
Panel Battery
Faults
RF Battery/PSU
Faults
RF Battery/PSU
Panel Battery
Faults
Faults