Eaton i-on series Engineering Manual page 118

Installer Menu Options
Channel 6
Channel 7
Channel 8
Note: In EUR versions the default for Channel 5 is Zone Omit (setting).
Table 4a and 4b shows the events available. You can key-in the two-digit numbers shown
next to each event in order to display that event type on the keypad. Table 4a applies to
UK systems. Table 4b applies to EUR systems.
00. Not used
01. Fire Alarm
02. Hold Up Alarm
03. Burglar Alarm
04. Open/Close
05. Alarm Abort
06. Technical Alarm
07. Confirmed Alarm
08. RF Low Battery
09. RF Supervision (see note 4)
10. RF Jamming (see note 4)
11. Mains Fail (see note 5)
00. Not used
01. Fire Alarm
02. Hold Up Alarm
03. Burglar Alarm
04. Open/Close
05. Alarm Abort
06. Technical Alarm
07. Confirmed Alarm
08. RF Low Battery
09. RF Supervision (see note 4)
Notes:
1. Open and Close provide the same functions as Open/Close, but on two separate
channels.
2. Zone Omitted - the control unit sends this signal for five seconds when a user omits
a zone.
Page 108
Tamper
Confirmed Alarm
General Fault
Table 4a. Fast Format Events (UK Systems)
12. Tamper (see note 6)
13. Open (see note 1)
14. Close (see note 1)
15. Zone Omit - setting (see note 2)
16. Zone Omitted - system
17. General Fault
18. Masking
19. Duress Code
20. HUA Confirm
21. Burg Confirm Alarm
22. Burg Alarm P1 (partitioned system only)
.. and so on up to the maximum number of
partitions handled by the control unit. For example
on an i-on160EX:
42. Burg Alarm P20 (partitioned system only)
Table 4b. Fast Format Events (EUR Systems)
10. RF Jamming (see note 4)
11. Mains Fail (see note 5)
12. Tamper
13. Open (see note 1)
14. Close (see note 1)
15. Zone Omit - setting (see note 2)
16. General Fault
17. Masking
18. Duress Code
19. Burg Alarm P1 (partitioned system only)
.. and so on up to the maximum number of
partitions handled by the control unit. For example
on an i-on160EX:
38. Burg Alarm P20 (partitioned system only)
i-on Range