Installer Menu Options; Detectors/Devices; Detectors - Eaton i-on series Engineering Manual

This section contains reference information for the options provided in the Installer Menu.

Detectors/Devices

Detectors

Adding or Deleting Radio Detectors
Add a Radio Detector To The System
To use a radio zone the control unit must learn the identity of the radio detector.
When learning detectors on an i-onEX range control unit you first select a radio expander
to assign that detector to, and then learn the detector's identity. Remember that EXP-R10
expanders can learn 10 radio detectors, while EXP-R30 expanders can learn 30 detectors.
(Note that the i-on30EX and i-on30EXD can only use the first 20 zones of those provided
by the EXP-R30.)
Deleting All Radio Detectors From The System
If you wish to remove all the radio detectors from the system first select
Detectors/Devices - Detectors – Add/Delete Detectors. Then:
On an i-on16 or i-on40 press  and you will see Delete All on the bottom line of the
display.
On an i-onEX control unit, when the display shows the first radio expander, press 
and you will see Delete All on the bottom line of the display.
When you delete all radio detectors the control unit sets all radio zones to Not Used, and
erases the identities of all the radio transmitters that it has learned.
Deleting All Zones From A Radio Expander
30 50 160
To delete all detectors from a single wireless expander select
Detectors/Devices - Detectors – Add/Delete Detectors from the Installer Menu. The bottom
line of the display shows the first of the radio expanders. Press  or  to display the
expander you wish to delete detectors from. Press  to select the expander. The bottom
line of the display shows the first of the zones belonging to that expander. Press  and
you will see Delete All on the display. Press  to select the option. The display asks you to
confirm your choice. Press  to finish deleting all the detectors from the expander, or  if
you wish to keep the detectors.
If you press  the control unit sets all zones belonging to the expander to Not Used, and
deletes the identities of all radio transmitters assigned to the expander.
Deleting a Single Detector
To delete an individual detector select Detectors/Devices - Detectors – Add/Delete
Detectors from the Installer Menu.
There are two options:
Delete Detector ID
Use this option to make the control unit "forget" the ID of the detector, but leave any
zone programming in place.

Installer Menu Options

i-on Range
Page 44