Wired Keypad; Radio Keypads; Expanders - Eaton i-on series Engineering Manual

Installer Menu Options
the sounder(s) for that partition. (The display will only present those partitions that have
zones allocated to them.)
Press  to turn the sounder on. Press  to turn the sounder off again. The display shows
the word "On" when the sounder should be operating and "Off" when the sounder should
be silent.

Wired Keypad

Use this menu option to test the keypad you are currently working on (you cannot test a
keypad remotely). When you start the test the bottom line of the display shows the keypad
name and bus address. All four ABCD LEDs should glow. The LEDs around the navigation
should all glow red. Every time you press a navigation key the LEDs change colour. Press
all the keys one by one. The display should show you the key you pressed. To test the
HUA keys press them both at the same time.
Note: While you are using the Test – Wired Keypad option activating a keypad HUA will
not cause a HUA alarm.
Press  to leave the test.

Radio Keypads

This option allows you to test the keys on the radio keypad. If you suspect that radio
keypad keys are not working then select the Test – Radio Keypads menu option and:
a) Press the A, B, C, D and Unset keys one after the other (wait two to three seconds
between each press to allow the keypad to transmit each message). The transmit LED
should flash for each key press. The display of the wired keypad from which you started
the test should show the appropriate letters.
b) Press both keys of the two-button HUA. The wired keypad display shows "Hold Up
Alarm Key".
c) Press the Unset key. The wired keypad display shows "System Unset Key".
d) Test all the numeric keys four at a time (six at a time if using six-digit codes, see
Appendix V) remembering to press A after each group of four (or six). For example, if you
press "4567A" the wired keypad display should show "4567A".
Note: You cannot test the "*" and "#" keys on a radio keypad.

Expanders

30 50 160
The Expanders test menu allows you to test individual expanders. For radio and wired
expanders you can check:
12V Input Voltage
Spare Zones
In addition, on wired Expanders you can check:
Load Current
EXP-PSUs have the following options:
Spare Zones
Page 128
This option shows the voltage on the 12V line in the bus cable,
at the connection to the expander.
This option shows the number of zones programmed as "Not
Used" on the expander.
This option shows the current being drawn by from the 12V Aux
connections on the expander. Note that the reading is in milli
Amps.
This option shows the number of zones programmed as "Not
Used" on the expander.
i-on Range