Appendix Iv: Programming A 762 Or 768/769 As An Output Module; Introduction; Before You Begin; Set Up The 762 Or 768/769 - Eaton i-on series Engineering Manual

i-on Range
Appendix IV: Programming a 762 or 768/769 as an

Introduction

Before You Begin

Carry out a radio site survey.

Set Up the 762 or 768/769

Enter Programming Mode

To enter programming for the first time (while installing a new unit):
1. Connect a suitable 12VDC power supply to the DC supply in
connector.
The display shows the version number of the software as two
alternating two-digit numbers, for example:
2. Press Select.
The display shows the first command in the menu: Manual Learn.
To enter programming while the unit is operating:
1. Open the 762r (or 768r/769r) case lid.
Note: If the unit is connected to an alarm control panel the tamper alarm
may sound.
The display is blank.
2. Press Select.
The display shows the first command in the menu: Manual Learn.

Set the Channels to Output Module Mode

Enter programming mode if the 762r or 768r/769r is not already there.
Press Select until the display shows the Output Mode command "OP":
3.
4. Press Set.
The display shows the first channel number.
5. Press Set again.
The display shows the channel's current mode, for example:
Press Select until the display shows "n6", the Output Module Mode:
6.
7. Press Set.
The display shows the Output Mode command "OP" again:
8. Press Set.
The display shows the first channel number:
Output Module
01 00
Ln
Ln
Ln
OP
C1
n1
n6
OP
C1
Page 149