Transferring To Another Keypad; To Leave The Installer Menu At Any Time - Eaton i-on series Engineering Manual

i-on Range
Once the lock out time has expired then the user can try and key in their access code
again. If they still key an incorrect code then the system will lock all keypads for another 90
seconds, but will not start another tamper alarm.
An "Excess Keys Tamper" can also occur if:
Any user presents an unrecognised prox tag to a keypad four times consecutively.
An installer or any user enters their access code incorrectly four times in a row while
attempting to gain access to the web browser.

Transferring to Another Keypad

While in the Installer Menu, you can transfer to any other wired keypad without leaving the
Installer Menu. To do this simply go to any other wired keypad and enter the Installer
access code. The new keypad will pick up your position in the Installer Menu. The keypad
you have left will briefly display the message "Installer session transferred" for 5 seconds
before reverting to the time and date.

To leave the Installer Menu at any time:


1. Press until the display shows:
2. Replace the control unit lid (if you removed it earlier).
Ensure the control unit tamper switch is closed.
Press  to leave Installer menu.
3.
(Press  if you do not want to leave the menu.)
The display shows:
The control unit scans the bus to check for any devices
that have been added or removed without using the
installer menu. On a large system this may take
several seconds.
When the control unit has finished scanning the bus,
the display shows the time and date. The system is
ready for use.
Duplicated Bus Devices
If the control unit finds that two bus devices have the
same bus address when you try to leave Installer
Menu, then it will show the duplicated addresses on
the keypad screen.
You must press  to re-enter the Installer Menu, and
then go and re-address one of the duplicated devices.
Missing or Extra Bus Devices
If the control unit finds a device missing, or one with an
address that has not been added using the Installer
Menu then the display shows, for example:
The top line of the display shows the number of new
devices found, and the number of existing devices
missing (lost). The bottom line of the display shows the
first in the list of found and lost devices.
Basic Programming Procedures








Page 13