LP 100R Laser Printer Operator's Guide
System Program
Installing the System Program
Note: Do not attempt to execute this function unless you are being guided by
SATO or your printer representative either by telephone or in person.
1. If the POWER LED is not green, press it for approximately 1 second and
release.
2. When the System Start-up screen displays, press the OFFLINE switch to
change the printer from the Online Idle mode to the Offline Idle mode.
3. Press Menu to display the Main Menu.
4. Select Advanced from the Main Menu and press Enter.
5. Select Supervisor from the Advanced Menu and press Enter.
Note: If access to the software is password protected, an Enter Password
prompt displays. See
6. Select Files from the Supervisor Menu and press Enter.
7. The following screen displays:
Rev: 1
page 6-39
for the rules governing password protection.
Figure B-24. Files System Program selected.
Page B-27
of 60 pages
Appendix B: Managing Files
April, 2014