LP 100R Laser Printer Operator's Guide
Password Enable Function
The Password Enable function allows you to either initiate or terminate password
protection.
If password protection is enabled, access to the Supervisor Menu is inhibited until
a valid password is entered.
Password Enable Function Access
1. Press the Up or Down triangle on the Supervisor Menu to move the selection
bar to the Password Enable function.
2. Press Enter, which causes the following Password Enable screen to display:
Note:
Brackets ( [ ] ) around either Disabled or Enabled indicate that it is the default
configuration password status.
An arrow () pointing to either Enabled or Disabled indicates the status
assigned to the current configuration.
Rev: 1
Figure 6-27. Password Enable menu.
Page 6-39
of 128 pages
Chapter 6: Supervisory Functions
April, 2014