LP 100R Laser Printer Operator's Guide
3. The number of characters per inch can be increased in 0.1000" increments,
from a minimum of 0.1000" to a maximum of 30.0000".
4. The number of characters per inch can be increased or decreased in 2 different
ways:
Enter the desired number of characters on the numeric keypad and then
press Enter.
or
Move the Up or Down triangle (to increase or decrease the number of
characters) and then press Enter.
Note:
Pressing Enter after any Printer Setup function has been executed saves the
function. However, it does not store the function.
When the configuration completes, press Back until the Store Configuration
screen displays, and then follow the procedures for executing the Store
function (see
Rev: 1
page
6-63).
Page 6-78
of 128 pages
Chapter 6: Supervisory Functions
April, 2014