Table of Contents
Advertisement
LP 100R Laser Printer Operator's Guide
KodescriptPlus™ Status and Error Codes
All KodescriptPlus code numbers appear in the lower right corner of the printer's
display. In addition, an explanation of status and error codes will be sent to the
monitor, COM2, or the display, as long as Field Check is set to on and the output is
set to one of the above devices.
The following groupings apply to KodescriptPlus codes:
Codes 01-15
These codes are Status codes, which indicate the stage of processing currently
active in the printer controller.
Codes 16-50
These are warning codes. An illegal procedure or invalid data was encountered
during processing. The controller continues processing and printing the file, but
1 warning beep sounds, and the code number is displayed on the printer.
Codes 51-80
These are error codes. An error code indicates that an incorrect series of
commands has been encountered or a command has been omitted. The controller
stops processing until the operator intervenes, and 3 warning beeps sound. The
printer will remain in the offline state until the operator presses the ONLINE
switch.
Codes 81-99
These are fatal codes. A significant error has occurred that causes the controller to
abort. The printer beeps continuously, and the controller no longer functions
correctly. Reset the printer by turning it off, waiting 20 seconds, and turning it on
again.
Rev: 1
Page 5-24
of 30 pages
Chapter 5: Problem Solving
April, 2014
Advertisement
Table of Contents
