LP 100R Laser Printer Operator's Guide
Font Detail
The Font Detail selection prints a sample of every character available when the
Symbol Set and Primary Font are used in conjunction with one another. This can
be very helpful when you want to verify the symbols that can be printed in the
higher ASCII character set.
Note: A Font Detail can not be printed while a print job is in progress.
1. Press the Up or Down triangle on the Test Prints menu to move the selection
bar to the Font Detail function.
2. Press Enter, which causes the following screen to display while the Font Detail
is printing:
3. To terminate printing, press Clear.
4. When printing is terminated, the system returns to the Supervisor Menu.
5. Press Feed until the printed form completely ejects from the printer.
Rev: 1
Figure 6-17. Font Detail screen.
Page 6-23
of 128 pages
Chapter 6: Supervisory Functions
April, 2014