LP 100R Laser Printer Operator's Guide
Ethernet Setup
Note: The Ethernet settings can not be changed when a print job is in progress.
1. Press the Up or Down triangle on the Interface Setup menu to move the
selection bar to the Ethernet function.
2. Press Enter, which causes the following Ethernet Setup menu to display:
3. The functions that can be selected from this menu include:
Enable Ethernet
Host Protocol
Static IP Settings
DHCP IP Settings
Activate New Settings
Job Trace
Windows Network Printing
Raw Printing
Rev: 1
Figure 6-20. Ethernet Setup menu.
Page 6-28
of 128 pages
Chapter 6: Supervisory Functions
April, 2014